Capacitors

By -
Move Time!
Have you ever wanted to blow something up. Well you can't but above
there is a capacitor exploding if the video works.


This is how the solve the problem of charging a capacitor too fast. They add
a resistor. A inductor would work better but why spend the money.

When adding capacitors you add them like opposite of resistors.
Taking the integral of graphs that represents the voltages going through an amp.


 The following graphs are what we did on the white board but on the waveform.
This was an induced wave at 1k Hz


Same as the previous one but at 2k Hz

Summary

Each of the graphs acted the way that we thought we would. Some of the
graphs as a flat peak witch means that we were most likely saturating the capacitor.
Besides that the we nailed this one.


Comments

Post a Comment

Popular posts from this blog

SuperPosition

By -
Image
We are just reviewing what we did in our lass class meeting. It was a simple mess problem. Why cant all problems be mess. He should only ask us to fin the current of a circuit and not the voltages. I did not really understand what he was doing here. You are suppose to assume that the voltage is a random number then solve for everything else on the circuit then when you get to the other voltage source you see the ration that you are off by then multiply everything else by it and then you will get your answer. Lab (Super Position II) I don't know how to rotate this picture, but it is our first example of superposition. We are suppose to find the currents at places with superposition even though mesh law is better for this situation. This is how we set up our "breadboard". We try to make it look like the white board setup to make it easier to read and determine what resistor We are just measuring the voltage drop on each resistor. With t...
Read more

LRC

By -
Image
Looking back to this day in lab made me wonder how it looked so hard before. We just had to follow some simple steps to find "a" and "w" . Then find s1 and s2 for the circuit This was a different problem but here we determined if the circuit was over damping, under damped or critically damped F ollowing that we found the ratio of a/w. LRC Lab I n the pre-lab we had to theoretically find how the circuit would react to the given conditions  I t was a simple circuit as seen about. We has to measure the response across the Cap and Inductor.  Conclusion  In the end the circuit acted the way that we thought I would in the pre-lab. The graph below shows the discharge of the capacitor (I think).
Read more

PBP

By -
Image
This was some want something I was able to do. It took  me a while to get back into my mojo. OH... here is Q and B. I did not know what that meant  on the final. Lab In the pre-lab we needed to figure out how the circuit would  respond in many different frequencies. In the end we got good data and everything was the way it was suppose to be. It took a long time to just get the numbers. it felt like busy work.
Read more