Phasers 2

By -

Lab








Conclusion





Comments

Post a Comment

Popular posts from this blog

Operational Amplifier

By -
Image
Operational  Amplifier ( also known as Op-Amp) is the main topic of the day. Op-Amp does exactly what it sounds like it does. It increases the power that is supplied to it. However it doesn't create power out of know where. It depends on your power leads. Here we calculated the ratio that the voltages are going to be when you supply any voltage. The resistor will determine what the output will be. Lab This is our setup. We use a diagram online to make sure we used the right inputs and outputs for the OP 27. It was fairly simple since they made it really easy for you. We did run across some problems with the waveform because we did not turn on the 5v and -5v outputs, but we did figure it out at some point.                             Summary The graph above shows it all. We had an ideal slope. ...
Read more

Introduction to Engineering 44

By -
Image
Day1 These graphs are the representations of how voltage, current, power, and energy corresponds with each other. Lab of the Day Solderless Breadboards, Open-circuits and Short-circuits .23 is the resistance we measured with the Digital MultiMeter (DMM) between two holes in the same row on our breadboard.  We did not measure any resistance between two holes on opposite sides of the central channel. This is because they are not connected. With this completed circuit we where able to measure resistance in the breadboard and wire. End of Lab This is an example of a problem the will most likely be on an exam. The picture is an example of how to measure the power absorbed in an unknown voltage point.
Read more

Mesh Analysis

By -
Image
Lab In this lab we are conforming that Michael is the best. But real talk this lab, like most labs we are conforming that the methods that we are learning in class on how to calculate voltages, currents, and resistors. The picture above is a simple resistor heavy circuit; which is good for use because with mesh analysis having majority resistor is fun and simple. We are measuring the current along this part of the setup. We are getting a negative do to the simple issue of thinking the current was going the opposite direction. Or we just connected the multi-meter wrong. We are just of course checking that the photo resistor works. This is the ideal waveform for the photocell I believe. Summary Mesh Analysis is the best type of analysis if you are looking for circuits. It is mostly a secondary method after you do an initial method. However this only works if you know each resistance on the circuit. During the lab we had very similar theatrical values a...
Read more